Roller is mainly used to support the conveyor belt and conveyor belt material, to ensure the stable operation of the conveyor belt. The correct selection of roller will directly affect the whole belt conveyor design is reasonable and in the use of the process can run normally.
(1) grooved roller
The groove angle of grooved roller is 35. And 45. Two species. The standard groove angle of the grooved roller is 35, which is the most commonly used in a conveyor is the 35 trough roller and the 35 groove shaped roller. There are 3 ways in the selection of these 2 kinds of rollers: one is the forward roller; the other is the forward roller (each set of rollers in each of the 5 sets of rollers). At present, there are two ways in the design.
(2) buffer roller
There are two forms of the groove angle of the buffer roller: 35 degrees and 45 degrees. When the cotton canvas core conveyor belt is selected, only the 35 trough buffer roller can be used. When using the 45 slot buffer roller, it can be used in the section where the material guide groove is not impacted by the material.
(3) transition roller
In the design, large capacity, long distance, conveyor belt tension and important conveyor should generally be set up transition section, transition section is the place where the transition roller. |